Switchback Section
2-7. Re-Feed Sensor (Switchback Unit A)
< Refer to the photograph below.>
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove Switchback unit A.
3. Unplug the wire connector of the Re-feed sensor and remove the sensor.
Note: After the replacement, check the operation by test mode 1109 (re-feed sensor).
2-8. Re-Feed Roller (Switchback Unit A)
< Refer to the photograph below.>
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove Switchback unit A.
3. Remove the gear. (6 mm dia. E-ring (1 pc))
4. Remove the metal bushing (2 pcs). (6 mm dia. E-ring (2 pcs))
5. Remove the re-feed roller.
2-9. Switchback Roller (Switchback Unit A)
< Refer to the photograph below.>
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove Switchback unit A.
3. Remove the metal bushing (2 pcs). (6 mm dia. E-ring (2 pcs))
4. Remove the switchback roller.
(Refer to the instructions in this Chapter.)
(Refer to the instructions in this Chapter.)
(Refer to the instructions in this Chapter.)
Re-feed roller
Interlock switch
Re-feed sensor
Switchback sensor
[ 10-12 ]
Switchback roller
ComColor Series (Revision 2.4)