Riso ComColor X1 series Technical Manual page 472

Type U06: Scanner lock settings error
The scanner setting has not been completed.
Display
Call service. (The lock not yet released.)
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Clear Note: To resolve the underlying problem, access test mode 05715 and set the scanner locked setting to 0
(operation allowed).
Point Description
4330
Scanner locked settings prevent operation.
Type U07: Scanner EEPROM error
The scanner settings are not realized properly.
Display
Call service.
Clear
Turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
4130
The serial number stored in EEPROM has not been set.
4131
The test mode setting values stored in EEPROM are out of range.
4132 The default image processing setting values stored in EEPROM are out of range.
Some of setting values on Test mode No.5900, 5901, 5902, 5903, 5904 & 5905 are out of range.
4134
To solve this error, set them into the value in the range.
Type U08: Scanner profi ling data error
The scanner settings are not realized properly.
Display
Call service.
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Clear Note: To resolve the underlying problem, access test mode 5406 (scanner profi ling mode) to store scanner
profi ling data in fl ash memory. If the error persists, cool off the unit and access test mode 5406 again.
Point Description
4360
Scanner profi ling data is not stored in fl ash memory after the scanner starts up.
4361
Valid profi ling data was not generated when profi ling mode was accessed in test mode.
Type U09: Mail maker motor lock error
The Mail maker has an error.
Display
Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
3490
MM Tamper Feed Motor lock
3491
MM Ejection Elevation Motor lock
3492 MM Ejection Motor lock
3493
Detected motor malfunction when operate unit check of Test mode.
3494
Failed to initialize the mechanism. (Incorrect motor home position, Motor lock)
Received wrong paper information from the printer unit.
3495
Could not confi rm the paper.(Body or Form)
3496 Failed to stop paper transportation.
Failed to detect the home position of the MM Top Tamp Motor.
3497
Misalignment of the tip plate (Motor synchronization loss, Malfunction of the MM Top Tamper HP Sensor, etc.)
Failed to detect the home position of the MM Tamper Nip Motor.
3498
(MM Tamper Nip Motor malfunction, Malfunction of the MM Tamper Nip HP Sensor, etc.)
Failed to detect the home position of the MM Body Fold Set Motor.
3499 Misalignment of the switching fl ipper (Motor synchronization loss, Malfunction of the MM Body Fold Set HP
Sensor, etc.)
Failed to detect the home position of the MM Form Entrance Nip Motor.
3500
(MM Form Entrance Nip Motor malfunction, Malfunction of the MM Form Nip HP Sensor, etc.)
Failed to detect the home position of the MM Gluing Motor.
3501
(MM Gluing Motor malfunction, Malfunction of the MM Gluing HP Sensor, etc.)
3518 MM Flap Fold Motor lock
3629
Mail Maker not equipped ejection place specifi ed by the printer unit.
[ 15-41 ]
Panel Messages