Staple Position Adjustment - Riso ComColor X1 series Technical Manual

4. Staple position adjustment

4-1. Staple angle position adjustment
> This is a mechanical adjustment.
(1) Perform printing or print test pattern to check for staple position deviations.
Specification for the staple position is shown on the sketch, below:
(2) Make the necessary mechanical adjustments if deviation is observed in the staple position, referring to the
photographs and explanations given on this page and next page.
• If the stapling is slanted in an angle:
B
A
B
A
>
A
A = B = 6.0 ± 2.0 mm
< The Stapler Rail is slanted.>
<
B or A B
if the Stapler Rail
is slanted the other way.
If the stapled positions are slanted (measurement
A differs from that of B), move this screw (either
the one in the FRONT or one on the REAR) into
the elongated hole to allow the Stapler Rail to
straighten.
Elongated hole used for the adjustment.
Available 1 in FRONT and 1 in REAR.
Use either one of the elongated hole to straighten
the Rail alignment -- do not use both.
[ 24-91 ]
Multifunction Finisher II (option)
x1 Series ComColor (Revision 0.9)