Paper Detection Sensors Of Trays 1 To 3 (3 Sets); Stripper Plates 1, 2 Or 3 - Riso ComColor X1 series Technical Manual

2-7. Paper Detection Sensors of Trays 1 to 3 (3 Sets)

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Follow the instruction given on the previous pages of this chapter and remove the Internal Paper Feed Unit out
of the machine of the tray of which the Upper limit sensor needs to be replaced.
3. Remove the Upper limit sensor from the detached Internal paper feed unit
Note: After replacement, check operation in test modes 1007, 1008 or 1009 (paper detection sensor) depending
on which Paper detection sensor was replaced.

2-8. Stripper Plates 1, 2 or 3.

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Pull out and remove all three Internal Paper Feed Trays from the machine.
3. Remove the pickup roller (Pickup roller clip (1 pc)) for which the Stripper plate is to be replaced.
4. Remove the stripper holder.
5. Remove the stripper plate. (It is attached with double-sided tape.)
Release the Stripper holder with
fingers while pushing up the
Stripper pressure release lever
with other finger.
< Internal Paper Feed Unit >
< BOTTOM View >
[ 5-21 ]
< TOP View >
Paper detection sensor
Stripper Plate
ComColor Series (Revision 2.4)
Registration Section