Riso ComColor X1 series Technical Manual page 479

Panel Messages
Type U91: HCS Motor Lock
The high capacity stacker has an error.
Display Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
3614
HCS Entering Motor lock
3615 HCS Reverse Motor lock
3616
HCS Middle Transfer Motor lock
3617
HCS Ejection Motor lock
3618 HCS Elevator Motor lock
3619 HCS Offset Guide Motor lock
3620
HCS Side Fence Motor lock
3621
HCS End Fence Moor lock
3622 HCS Ejection Wing Motor lock
Could not detect the HCS Tray Paper Jam Sensor in certain period during the HCS Elevator Motor rotating.
Variation Code
3630 1-2
1: HCS Offset Unit Guide Sensor is ON.
2: HCS End Guide Plate Sensor is ON.
3880 Detected overcurrent of the HCS Elevator Motor.
3881
Occurs when could not detect drive waveform after the HCS Elevator Motor starts.
Type U92: PB memory error
An error has occurred in the perfect binder.
Display
Press the reset key or Reboot by press the Sub Power Key
If recovery fails, contact a service provider.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
EEPROM エラー
3650
Type U93: External controller error
An error has occurred in the external CI.
Display
Check the external CI.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
The external controller hard disk is full.
5001
There is less than 1 GB of free space, and subsequent jobs cannot be processed.
The external controller hard disk is corrupted.
5002 The fi le system check (fsck) conducted when the external controller starts up has detected an unrecoverable
error.
5003 The external controller hard disk drive can no longer operate correctly.
There is no dongle in the external controller, or the inserted dongle conforms to regional specifi cations other
5004 than those for the hard disk drive (for example, a Japanese-specifi cation hard disk drive is used with a dongle
for overseas use).
5005
Cannot communicate with the external controller (detected by the controller PCB unit)
Communication (transmission) is possible with the external controller, but it does not follow the correct
5006
sequence (detected by the external controller).
Communication (reception) is possible with the external controller, but it does not follow the correct sequence
5007
(detected by the controller PCB unit).
A power OFF command is sent from the ComColor to the external controller, but the external controller is not
5008
deactivated (detected by the controller PCB unit).
Wait time is one minute.
When scanned data cannot be received correctly by the external controller (detected by the controller PCB
5009
unit)
Could not perform some settings correctly on the external controller.
5010
(When setting were made from the unit to the external controller.)
[ 15-48 ]