Disassembly; Cutting The Ink Tubes - Riso ComColor X1 series Technical Manual

2. Disassembly

2-1. Cutting the Ink Tubes

Follow this Ink tube cutting procedure when instructed in replacing certain ink circulation parts.
1. Cut the ink tubes at the Cut-mark line.
< Cut from where the black line is imprinted on the existing ink tube.>
Use a nipper to cut the ink tube.
The nipper should cut the tube right angle to the tube along the imprinted black line.
2. Allowance in the cutting area.
Cut the tube within plus or minus 5 mm from the imprinted black line.
Right Angle
Cut-mark line
5 mm 5 mm
[ 11A-15 ]
Tube (sample)
Nipper
ComColor Series (Revision 2.4)
Ink Flow Section