Pickup Roller; Scraper Roller; Stripper Plate - Riso ComColor X1 series Technical Manual

2-15. Pickup Roller

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the plastic clip of the pickup shaft.
3. Remove the pickup roller assembly by sliding it towards the front of the machine.
4. Remove the bushing and plastic paper feed support roller.
5. Remove the Pickup roller plastic clip.
6. Remove the Pickup roller.
Note:In mounting the Pickup roller back on the machine, make sure the side with the one-way clutch faces the
front of the machine.

2-16. Scraper Roller

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the scraper roller clip.
3. Remove the scraper roller along with the shaft and metal piece.
Note: In mounting the Scraper roller back on the machine, make sure the side with the one-way clutch faces the
front of the machine.
Pickup shaft

2-17. Stripper Plate

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Lower the sliding lock on the left side of the stripper unit and slide the locking knob down.
3. Push the removal lever on the right side.
4. Remove the stripper sub unit from the guide plate.
5. Remove the stripper base, and then slide the stripper cover off.
6. Detach the stripper plate. (It is attached with double-sided tape.)
Stripper cover
Clip
Stripper plate
[ 4-23 ]
Scraper roller
Stripper base
External Paper Feed Section
Clip Pickup roller
ComColor Series (Revision 2.4)