Riso ComColor X1 series Technical Manual page 236

Ink Flow Section
6. Disconnect the four drainage tubes on the overflow pan side. Insert the ends in the port in the overflow pan.
<Prior to the insertion of the drainage tubes into the Ink drain port of the Overflow pan, remove the sponge if the
sponge exists.>
Note: Be careful, because ink may drip when you remove the tubes.
< Refer to the photographs, sketch, and instructions on this page.>
Disconnect the Ink drainage tube at the bottom.
Do not disconnect the Ink drainage tube from the top -- the ink will flow down on the floor.
Note: Insert drainage tubes so that they go into the groove (ink drain port) on the overflow pan.
Overflow pan
< Refer to the photographs on the next page for further details.>
Unhook the Ink drainage tube from the tube
holder and straighten the tube to allow smooth
drainage of the ink.
If sponges exist in these two places,
remove these sponges and throw them away.
This is to allow smooth drainage of the ink.
[ 11A-24 ]
Do the same to the Ink
drainage tubes of
all the colors.
ComColor Series (Revision 2.4)