Disassembly; Internal Paper Feed Unit (Tray 1) - Riso ComColor X1 series Technical Manual

2. Disassembly

2-1. Internal Paper Feed Unit (Tray 1)

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the center inner cover. (Refer to Chapter 2.)
3. Remove the left inner cover. (Refer to Chapter 2.)
4. Remove the bottom inner cover. (Refer to Chapter 2.)
5. Remove the rear cover center assembly. (Refer to Chapter 2.)
6. Put the power supply unit in maintenance position. (W sems screw 4x8 (2 pcs))
7. Remove the front door lock mechanism. (IT3C screw 4x8 (4 pcs))
8. Move the maintenance unit (ink pan) to the retracted position.
9. To keep the BP unit transfer belt clean and free of ink, put a sheet of paper on it.
10. Move the BP unit to the upper limit position.
11. Pull out tray 1.
12. Disconnect the wire connector and remove internal paper feed clutch 1. (5 mm dia. E-ring)
13. Slide the gear and gear-pulley out of the way (1 pc each). (6 mm dia. E-ring (1 pc each))
14. Remove the metal bushing. (6 mm dia. E-ring)
Slide the Gear and Gear-Pulley maximum out to allow the metal bushing to come off.
[ 5-15 ]
Registration Section
ComColor Series (Revision 2.4)