Riso ComColor X1 series Technical Manual page 470

4-2. Unit Errors (U)
Type U01: Scanner connection error
Communication with the scanner is disconnected.
Display Check the scanner for power supply or connection and press RESET key.
If recovery has failed, call service.
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
It may also be possible to clear the error as follows:
Clear
" Reconnect the scanner.
" Restart the scanner.
" In the case of U01-0220 only, you may need to download scanner fi rmware.
Point Description
0063 The USB connection is Full-Speed (12 Mbps), not Hi-Speed (480 Mbps).
0202
During communication with the scanner, the scanner did not respond.
0219
The scanner is disconnected or OFF.
0220
No scanner fi rmware
0256 Old fi rmware scanner connected with new version unit. (Need fi rmware upgrade on the scanner)
0257
Connected scanner is not supported. (Connect correct scanner model)
4120
The USB connection is Full-Speed (12 Mbps), not Hi-Speed (480 Mbps).
4121 The USB cable was disconnected during image data transfer.
Type U02: Scanner communication error
Communication with the scanner failed.
Display Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
It may also be possible to clear the error as follows:
Clear
• Reconnect the scanner.
• Restart the scanner.
Point Description
0201 During communication with the scanner, an unspecifi ed command was received from scanner.
0203
The scanning parameters are incorrect.
0205
The scanner communication program failed to allocate memory.
0207
Data for testing scanner data monitoring could not be written.
0210 Scanner information fi le could not be opened.
0211
Image fi le from the scanner could not be opened.
0213
Image data from the scanner could not be saved.
0215 Image data could not be received from the scanner.
0216
Data for printing could not be received from the scanner.
0217
Error on the Scanner.
0218
The next original could not be detected within 30 seconds during AF scanning.
0221 Incorrect version of command for scanner communication.
Data transfer failed between the controller and scanner, due to a bad USB connection, timeout, or other
4200
reasons.
Scanning could not be started from the controller when the next original was determined to be ready in
4201
communication between the controller and scanner.
[ 15-39 ]
Panel Messages