Riso ComColor X1 series Technical Manual page 508

Type W161: Envelope Form Set Error 3
Set envelope form ( ) in the direction below.
Display
High capacity feeder: Star to right front
Feed tray1–3: Circle to left front.
Do one of the following.
• Place the paper on the tray. (Empty tray that targetted to Auto tray)
• Press the Tray change button. (Select the tray other than Auto tray)
Clear • Press the Tray change button. (Select the target tray to Auto tray)
• Press the Continue button.
• Press the Cancel button.
• Delete the print job.
Point Description
There were no appropriate paper on the mail form tray that was specifi ed as automatic. (Connected to HCF
3704 1-2
unit)
(Mail form paper: Simplex paper transfer)
Type W162: Envelope Form Set Error 4
Set envelope form ( ) in the direction below.
Display
High capacity feeder: Circle to left front
Feed tray1–3: Star to right front.
Do one of the following.
• Place the paper on the tray. (Empty tray that targetted to Auto tray)
• Press the Tray change button. (Select the tray other than Auto tray)
Clear • Press the Tray change button. (Select the target tray to Auto tray)
• Press the Continue button.
• Press the Cancel button.
• Delete the print job.
Point Description
There were no appropriate paper on the mail form tray that was specifi ed as automatic. (Connected to HCF
3705 1-2
unit)
(Mail form paper: Duplex paper transfer)
Type W170: Env Form Set Error (STD/SPX)
Display
Set envelope form in the standard tray so that the star mark comes to the right front side.
Do one of the following.
• Place the paper on the tray.
Clear
• Press the Tray change button. (Select the tray other than Paper Feed Tray)
• Press the Cancel button.
• Delete the print job.
Point Description
After specify [Paper feed tray] as [Mail form tray] in manually, it became the state of one of the following:
• There is no paper on the paper feed tray
3710 1-2
• There is no appropriate paper on the paper feed tray
(Mail form paper: Simplex paper transfer)
Type W171: Env Form Set Error (STD/DBL)
Display
Set envelope form in the standard tray so that the circle mark comes to the left front side.
Do one of the following.
• Place the paper on the tray.
Clear • Press the Tray change button. (Select the tray other than Paper Feed Tray)
• Press the Cancel button.
• Delete the print job.
Point Description
After specify [Paper feed tray] as [Mail form tray] in manually, it became the state of one of the following:
• There is no paper on the paper feed tray
3711 1-2
• There is no appropriate paper on the paper feed tray
(Mail form paper: Duplex paper transfer)
[ 15-77 ]
Panel Messages