Riso ComColor X1 series Technical Manual page 425

Electronic Compnents
13. Select the User Category and then push the
NOTE: It is of no problem if the
Use test mode No. 505 [SETUP WIZARD INITIALIZE] later and make the selection if needed.
CAUTION ! : Do not press the
The Setup Wizard display closes and you will be stuck with the Japanese Language again.
14. The Setup Wizard ends and the user operation display is shown.
NOTE: The operation panel language is changed to the Language you have selected. (Below is a sample of English
Language.)
After the above [Select Operation mode] panel display appears, turn OFF the machine power, and then proceed
with the machine Firmware upgrading procedure.
Rev.1.00
OK button on the following display.
OK button is pushed without making the selection.
Cancel button.
- END -
[ 14-74 ]