Riso ComColor X1 series Technical Manual page 905

Multifunction Finisher II (option)
2. Punch position adjustment
> The adjustment is made by changing the parameter settings on Test Modes.
> Separate adjustments must be made for each paper size.
(1) Perform printing or print test pattern to check for punch position deviations.
(2) If punch position deviation is detected, adjust the Test Mode parameters.
• Increasing the Test Mode parameter value moves the punch position toward the REAR.
NOTE:
The puncher pin pitches are mechanically fixed for 2/4 and 3/4 punch holes. Therefore the punch hole pitches
cannot be adjusted.
REAR
FRONT
Specifications
Paper size
A4 SEF
Letter SEF, 8.5 x 14 SEF
A3 SEF, A4 LEF
11 x 17 SEF, 8.5 x 11 LEF
B4 SEF, B5 LEF
List of Test modes
ComColor
HC Finisher
Multipurpose
< as Reference>
Finisher
Test Mode No.
Test Mode No.
4733 763-213
4734 763-214
4735 763-215
A
Dimension (mm)
65.0
67.95
108.5
99.7
88.5
Program
Item
Default
PUNCH SIDE
97 1 = 0.125 mm 10–170
REGI ADJ1
PUNCH SIDE
85 1 = 0.125 mm 10–170
REGI ADJ2
PUNCH SIDE
86 1 = 0.125 mm 10–170
REGI ADJ3
[ 24-90 ]
REAR
FRONT
B
Dimension (mm)
28.5
19.7
Range
Unit/Step (min./
max.)
Punch registration adjustment.
Punch registration adjustment for paper
width of 297 mm.
Punch registration adjustment.
2/3 Puncher:
203 mm ≤ paper width ≤ 285 mm
2/4 Puncher:
216 mm < paper width ≤ 285 mm
Punch registration adjustment.
2/4 Puncher:
Adjusts the position in the direction of
the punch hole side registration when
203 mm < paper width ≤ 216 mm.
x1 series ComColor (Revision 0.9)
Description