Riso ComColor X1 series Technical Manual page 813

HS5000 Scanner (option)
White roller and nearby parts
(1) Loosen the tension on the 2 tensioners on the rear of the AF unit.
(2) Remove 2 E-rings and detach the pulleys. (refer to the above photograph)
(3) Remove 3 E-rings and 2 bearings.
(4) From the front of the AF unit, remove 3 metal clips, 2 gears and 2 bearings from the two shafts shown on the
photograph below. (Small gear will also come off when taking the bearing out.)
(5) Remove 3 E-rings and 2 bearings.
(6) Remove the three rollers attached as an assembly.
Watch out not to loose the springs from the both ends of the roller assembly.
Tensioners Remove the parts on these two shafts.
Remove parts attached
onto these two shafts.
[ 20-34 ]
Small gear
x1 series ComColor (Revision 0.9)