Riso ComColor X1 series Technical Manual page 316

Ink Flow Section
Sketches showing the steps to remove and to put back the KG Base Assembly on ComColor 3050 and 3010.
The basic instruction is the same as to that for ComColor 9050, 7050 and 7010.
1
2
3
4
or Co
5
6
SIDE VIEW
Head Holder Unit
REAR
2 Push
KG Base Assemby
Slide while pulling
SIDE VIEW
Head Holder Unit
REAR
Hooks (4 places)
Hold the circled portion
1
3
on the left and right of
the assembly with both
hands and bow down
the assembly lightly.
SIDE VIEW
Head Holder Unit
REAR
Free fall
KG Base Assemby
SIDE VIEW
Head Holder Unit
REAR
Insert the
1 3 Insert the 4 hooks in the lock holes.
positioning
pin.
4 hooks
KG Base positioning pin
KG Base Assemby
SIDE VIEW
Slide back the KG
Base with 4 hooks
in the Lock hole.
Head Holder Unit
REAR
KG Base Assemby
4 hooks
Pin
SIDE VIEW
Head Holder Unit
1
REAR
Insert the front Hooks in
the Head holder assembly
KG Base Assemby
FRONT
1 Pull down
FRONT
2 Slide out while pulling down
Pull down
KG Base Assemby
FRONT
2
1
Lift up
FRONT
Make the red highlighted portion
2
flat against the Head holder.
Hold the red-circled tip area
with one hand.
FRONT
Hold the red-circled tip area
with one hand.
2
Slide to the Front.
FRONT
front Hooks
Pin
[ 11A-104 ]
REMOVAL
PLACEMENT
ComColor Series (Revision 2.4)