Storage Position Sensor; Waste Ink Tank Sensor - Riso ComColor X1 series Technical Manual

2-6. Storage Position Sensor

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Open the waste ink cover. (Refer to the section on covers in Chapter 2.)
3. Unplug the wire connector of the storage position sensor and detach the sensor from the machine.
Maintenance unit arm (rear)

2-7. Waste Ink Tank Sensor

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the Rear cover. (Refer to Chapter 2)
3. Disconnect the two Connectors of the Waste ink tank sensors.
4. Remove the Sensor bracket with the two sensors attached. (IT 3 x 6 screw; 1 pc)
5. Detach the two sensors from the sensor bracket.
Do not remove this screw.
Screw to remove
Waste ink tank sensors
< connectors >
Storage position sensor
[ 12-15 ]
Waste Ink Section
ComColor Series (Revision 2.4)