Removing The Scissor Clamps - Riso ComColor X1 series Technical Manual

Ink Flow Section

2-3. Removing the Scissor Clamps

Scissor clamps, used for clamping tubes, are attached on the top of the head holder cover.
Remove them as follows.
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Open the front cover and remove the stoppers at two positions (IT3C screw 4x8 (1 pc each)) to remove the
Upper transfer unit. (Refer to paper transfer section information in Chapter 8.)
3. pull and slide the Upper transfer unit out of the machine.
4. Remove the scissor clamps attached to the top of the head holder cover.
Stopper
[ 11A-20 ]
Upper transfer unit
Scissor clamps
ComColor Series (Revision 2.4)