Riso ComColor X1 series Technical Manual page 877

Multifunction Finisher II (option)
(5) Disconnect the ground wire located on the rear. Unplug the three connectors from the PWB (printed-wire
board), detach the reusable band, and disconnect one intermediate connector.
Intermediate connector
(6) Remove the mounting screws (2 screws each) from front and rear, and remove the Stapler Unit.
> Note that there are two openings (round opening and elongated opening) for one of the two screws on front
and rear. The screws are generally installed in the round openings.
> Before removing the screws, inspect and note down whether they are installed in the round openings or
elongated openings.
If the screws are installed in the elongated openings, you must adjust the Stapler angle after reassembly.
< Front View >
Stapler
Remove these two screws
Unplug connectors of these 3 wires from PWB
If the screw is set on this elongated hole, the Stapler
mounting position is assumed to be adjusted.
Therefore, re-adjustment is necessary after the assembly.
Ground wire
Reusable band
< Rear View >
Stapler
[ 24-62 ]
Remove these two screws
x1 series ComColor (Revision 0.9)