Disassembly - Riso ComColor X1 series Technical Manual

2. Disassembly

2-1. Removing the Paddle Shaft Assembly
> The Paddles must be replaced at regular intervals. Check the counter using Test Mode No. 4603 "BOOKLET
PADDLE COUNT" to determine when to replace the Paddles.
(1) Pull out the Booklet Drawer Unit.
(2) Remove the KL-Clip from the shaft of the Paddle Shaft Assembly.
Remove this KL-Clip and slide this Metal Bushing
(3) Slide the bearing metal and dismount the Paddle Shaft Assembly.
(4) After replacing the Paddle Shaft Assembly, check to make sure that each Paddle is installed at the correct
position.
9.2 ± 0.3 mm
34.8 ± 0.3 mm
88.8 ± 0.3 mm
[ 24-73 ]
Multifunction Finisher II (option)
Paddle Shaft Assembly
x1 Series ComColor (Revision 0.9)