Riso ComColor X1 series Technical Manual page 482

Type U125: HCS unit hardware error
The high capacity stacker has an error.
Display Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
3628
Failed to collect equipment information from EEPROM, and informed as unknown equipment.
3866 Abnormal CRC in the HCS back-up data.
3867
Failed to recover HCS back-up data.
3868
Detected incorrect model information in the HCS back-up data.
3869 Detected abnormal status in HCS EEPROM.
3871 Timeout occurred during the serial transmission to HCS EEPROM as waiting to send.
3872
Timeout occurred during the serial transmission to HCS EEPROM as waiting for transmission completion.
3873
Detected a received error during the serial transmission to HCS EEPROM.
3874 Timeout occurred during the serial transmission to HCS EEPROM as waiting for received data completion.
3875
Failed to write data in HCS fl ash data.
Type U126: HCS unit software error
The high capacity stacker has an error.
Display Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
3865
Detected the undefi ned data during HCS data backing up.
3870 Detected incorrect address in the HCS EEPROM.
3876
Detected abnormal data size during writing data in the HCS fl ash data.
3877
Detected incorrect address during writing data into the HCS fl ash data.
Type U127: Mail Maker hardware error
The Mail maker has an error.
Display
Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
5554 At power ON (Mail Maker), 24V power failure has occurred for Mail Maker drive PCB 1.
5555
At power ON (Mail Maker), 36V power failure has occurred for Mail Maker drive PCB 1.
5556
At power ON (Mail Maker), 24V power failure has occurred for Mail Maker drive PCB 2.
5557 At power ON (Mail Maker), 36V power failure has occurred for Mail Maker drive PCB 2.
Type U128: MM EEPROM error
The Mail maker has an error.
Display
Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
3661 Could not refer the data in EEPROM.
3662
Could not write the data to EEPROM correctly.
[ 15-51 ]
Panel Messages