Riso ComColor X1 series Technical Manual page 494

Type W51: Request to start recovery operations
Display
Ready to resume. Press the [Confi rm] button.
Clear
Press the Confi rm button.
Point Description
When the belt platen must be lowered to recover from a paper jam, this message is issued when user
1301
confi rmation is required.
Type W52: Check load capacity on tray
The number of sheets set in the tray might have exceeded the limit.
Display
Please check the tray. If recovery has failed, call service.
Clear
Point Description
1955
Tray 1 upper limit sensor is ON when the tray 1 inserted. (Paper overload on the tray 1)
1956 Tray 2 upper limit sensor is ON when the tray 2 inserted. (Paper overload on the tray 2)
1957
Tray 3 upper limit sensor is ON when the tray 3 inserted. (Paper overload on the tray 3)
Type W53: USB memory mounting error
USB fl ash drive is not found.
Display
Set the USB fl ash drive again and press "Retry" button.
Do one of the following.
• Disconnect the USB memory device.
Clear
• Press the Cancel button.
• Press the Save to Internal HDD button.
• Press the Retry button.
Point Description
0053 1
The USB memory device could not be mounted when scanning began (for scan fi les).
0053 2 The USB memory device could not be mounted when scanning began (for fi les other than scan fi les).
Type W54: Paper size error(Fold)
Paper of this size cannot be output with the current fold setting.
Display
Check the paper setting orientation or the printer settings.
Clear
Press the Close button.
Point Description
0314 1-2 3-fold printing was instructed in the paper size that cannot handle.
0315 1-2 2-fold printing was instructed in the paper size that cannot handle.
0316 1-2
Z-fold printing was instructed in the paper size that cannot handle.
Type W55: MM Stacker Full Error
Display
The mail stacker is full. Remove mails.
Do one of the following.
Clear
• Press the Cancel button.
• Delete the job.
Point Description
3534
Detected full tank by the MM Eject Tray Full Detection Sensor.
Type W56: Check paper size setting
The paper size may be incorrect.
Display
Check the paper guides, paper trays or paper size settings. (The job has been cancelled.)
Clear
Press the Close button.
Point Description
1300
The paper size detected by the system does not match the detected size of paper being transferred.
[ 15-63 ]
Panel Messages