Riso ComColor X1 series Technical Manual page 421

Electronic Compnents
The Japanese Language display, shown on the left hand side of the page, will display when the ComColor
machine is powered ON for the fi rst time after the Hard Disk replacement.
The English Language display, shown on the right hand side of the page, is the English reference of the
Japanese Language display on the left.
1. Push the Next button on the following display.
2. Select English or the Language of your choice, and then push the Next button on the following display.Since the
spare part Hard Disk contains low version machine fi rmware, you may not get your selection of language. In that
case, select your choice from those available, and re-select your language from the Admin setting after updating
the fi rmware on the machine.
CAUTION ! : If you do not select
display, you will be stuck with the Japanese Language again. Select the choice of your language and press the
button.
3. Select inch and then push the
NOTE: It is of no problem if the
ARD INITIALIZE] later and choose the correct selection or go into the Admin to make the selection.
CAUTION ! : Do not press the
The Setup Wizard display closes and you will be stuck with the Japanese Language again.
Rev.1.00
English or selection of your language, or if you press the Cancel button on this
Next button on the following display.
Next button is pushed with a wrong selection. Use test mode No. 505 [SETUP WIZ-
Cancel button.
[ 14-70 ]
Next