Riso ComColor X1 series Technical Manual page 870

Multifunction Finisher II (option)
(4) Separate the wires connected to the Punch Unit located on the rear.
1 motor connector,
2 wire connectors &
1 wire harness
1 connector & 1 reusable band
2 connectors & 1 reusable band
(5) Separate the wires from the metal plate at the middle section of the Punch Unit. (2 clamps, 1 reusable band.)
(6) Remove the four mounting screws and dismount the Punch Unit.
2 screws on front, 2 screws on rear.
Precaution in Assembly:
After installing the Punch Unit back on the Finisher, gently shake the Punch motor lightly, and confirm that the
bottom half of the Punch Unit swings freely, lightly. <The bottom half of the Punch Unit is in hanging state.>
If the Punch Unit does not swing at all, the Punch Unit is very likely to be installed incorrectly.
Check the clear plastic plate located at the entrance of the Punch Unit. If the Punch Unit is mounted on the
Finisher with this clear plastic plate riding over the Punch Unit, the Punch Unit will not operate correctly.
[ 24-55 ]
x1 Series ComColor (Revision 0.9)