Riso ComColor X1 series Technical Manual page 735

Hide thumbs Also See for ComColor X1 series:

Table of Contents

Face Down Offset Stapler

4-14. Control Board (PCB)

1. Remove the Rear Cover.

2. Disconnect all the wire connectors from the Control Board (PCB).

3. Remove the PCB mounting screw from the bottom right-hand corner of the PCB. (W-sems screw 4x8 (1 pc))

4. Release the Control Board (PCB) by unhooking the plastic hooks on the remaining three corners of the PCB.

Chapters

Table of Contents