Cartridge Holder Joint Drive Motor - Riso ComColor X1 series Technical Manual

Ink Flow Section

2-10. Cartridge Holder Joint Drive Motor

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Open the right front cover.
3. Remove the ink cartridges. (4 cartridges)
4. Remove the left and right top covers. (Refer to the section on covers in Chapter 2.)
5. Open the Ink cartridge holder unit to the vertical position following the instruction given in the, "Ink spill revention
from the Ink cartridge holder unit" procedure described earlier in this section.
6. Disconnect the harness and connector.
7. Remove the motor mounting screws. (IT screw 3x6 (2 pcs))
Screw driver
8. Remove the motor.
[ 11A-38 ]
Cartridge holder
joint drive motor
ComColor Series (Revision 2.4)