Riso ComColor X1 series Technical Manual page 228

Ink Flow Section
3. The cutting angle should be within 1.5 mm (approx. 10 degrees) from the imprinted marking.
4. Check with the eye for any left over tube on the cut area.
If any leftover piece(s) are left on the tube, cut the leftover piece off.
5. Insert the joint on the tube. If the joint is too tight to fit, put some ink on the tip of the tube to act as a lubrication.
< Too much ink to act as lubrication will cause the joint to slip off. Make sure not to put too much ink, and
confirm that the joint does not slip off.>
1.5 mm
Check for any leftover piece on the tube.
[ 11A-16 ]
ComColor Series (Revision 2.4)