Riso ComColor X1 series Technical Manual page 248

Ink Flow Section
12. Wait few minutes for the ink from the Ink cartridge holder unit to drain down into the Waste ink tank. Then at the
three-way joint of the ink drain tubes, use scissor clamps to clamp the tubes from the overflow pan of the Ink
cartridge holder unit and to the waste ink tank. (2 tubes.)
13. Disconnect the Ink drain tube from the ink cartridge holder unit at the three-way joint. Plug a rubber cap on the
tip of the unplugged ink drain tube to prevent ink from dripping out.
14. Likewise, plug the port of the three-way stopper from which above ink drain tube was unplugged, to prevent ink
drip.
Ink drain tube of the Ink
cartridge holder unit.
15. Use a nipper or a similar tool to cut the fastener (band) holding the ink drain tube where it emerges out from the
inside of the machine frame out towards the back.
16. Pull up the waste ink tube into the frame.
17. Restore the ink cartridge holder unit, which was standing, to its original flat position. Remove all four ink
absorbing papers from the Ink cartridge holder unit.
18. Remove the E-rings linking the arm plate of the ink cartridge holder unit to the bracket on the printer side. (6 mm
dia. E-ring (2 pcs))
19. Remove the Ink cartridge holder unit from the printer.
Unplug this ink drain tube from the 3-way joint.
E-rings
[ 11A-36 ]
ComColor Series (Revision 2.4)