Riso ComColor X1 series Technical Manual page 744

Option
13. Slide the Stapler Unit to the center of the unit.
14. Gently slide the front and rear Tamper Plates to the maximum outer position, making sure that the Stapler Unit
is centered not to interfere with the Taper Plate movement.
15. Remove the white plastic snap ring from the shaft of the Rake Roller, only from the REAR of the shaft.
16. Release the Metal Bushing from the bracket plate on the REAR side of the shaft first, and then do the same on
the FRONT side of the shaft.
［ 19-57 ］
Tamper Plate (rear)
White plastic snap ring (rear)
Metal Bushing
［ 19-57 ］
Face Down Offset Stapler
Tamper Plate (front)
Rake Roller Assembly