Riso ComColor X1 series Technical Manual page 819

Multifunction Finisher II (option)
2-2. Main functions (detailed explanation)
Booklet production
1) Printed paper sheets are folded in half and stapled at the center to form booklets.
2) You can select "2-fold + staple" or "2-fold (without staple).
3) Select from A3 SEF, B4 SEF, and A4 SEF.
4) Pagination is performed automatically for correct booklet production. Printing is performed based on the mode
selected (two-page layout, duplex, or sort mode).
5) In the case of left-hand booklets, the first page is the one facing down, at the bottom.
6) Stapling is automatically disabled if the number of pages is less than four.
7) Paper is discharged onto the Booklet Tray.
8) The function can process up to 15 sheets, including covers in the case of "2-fold + stapling" or up to 5 sheets
including covers in the case of "2-fold (without staple)."
Separate binding
1) This function produces separate booklets when the number of pages is too large for a booklet.
2) This function affects pagination and layout.
3) If the "2-fold + stapling" setting is selected, the function can process up to 15 sheets in auto mode or 1 to 15
sheets when the number of sheets is specified.
4) If the "2-fold" setting is selected, the function can process up to 5 sheets in auto mode or 1 to 5 sheets when
the number of sheets is specified.
5) You cannot use the "add cover" function with this function.
6) Even if the separate binding setting is set to OFF, the separate binding operation is performed if the print job
contains 61 or more original pages (21 pages or more when no stapling is performed). In such cases, the
stapler setting is ignored and paper sheets are discharged without being stapled.
Center binding margin
1) This function provides a binding margin at the center for booklet production.
2) The binding margin can be set to a value of between 0 and 50 mm.
3) If the "auto size reduction" function is set, the image printed will be scaled to fit the print area.
If the "auto size reduction" function is not set and the image to be printed extends beyond the print area, the
image sections outside the print area will not be printed.
Offset output
1) This function performs paper discharge operation by shifting the position of each sheet or set of printed pages
discharged onto the Stacker Tray according to settings.
2) The offset output function is automatically activated when the stapling function is used.
Stapling
1) This function staples 2 to 100 sheets and discharges sets of copied sheets.
2) Stapled sheets are discharged onto the Stacker Tray in offset positions.
3) The stapling and punching functions can be enabled simultaneously.
4) Select type of copy paper from A3 SEF, B4 SEF, A4 LEF/SEF, or B5 LEF.
5) Since staples are driven into paper from the bottom side, paper is discharged with this face side down. For
single-sided printing, paper is flipped over inside the printer.
6) Since staples are inserted at the trailing edge from the button side, the stapling positions cannot be adjusted
on the Finisher side. This means the print image is rotated inside the PS7R based on the setting before being
output.
7) If only one corner is stapled, a staple is inserted into the paper square if angled staple insertion is not possible.
LEF fed paper cannot be used.
[ 24-4 ] x1 series ComColor (Revision 0.9)