Riso ComColor X1 series Technical Manual page 231

10. Remove one thumb screw and one IT screw 4x8 (1 pc) from the Ink cartridge holder unit and the unit to the
vertical position. << Refer to the two photographs below.>>
< Make sure to screw the Lock arm to prevent the Ink cartridge holder from falling down.>
CAUTION:
Make sure to remove the ink absorbent paper the each time the Ink cartridge is pulled out or plugged into the
Ink cartridge unit. Then re-hook the ink absorbent paper in the instructed position, using a new piece of paper if
the previous one has already absorbed the ink.
Thumb screw IT screw 4x8 (1 pc)
[ 11A-19 ]
Fix the vertical position of the Ink cartridge holder unit
using a screw to prevent the holder from falling down.
Ink Flow Section
The ink absorbing paper should
stay in position to absorb any
ink that may drip when the Ink
cartridge holder is opened to
the vertical position.
ComColor Series (Revision 2.4)