Riso ComColor X1 series Technical Manual page 242

Ink Flow Section
Before going to step-1, bellow, confirm that the Flat cable has a good fold, or the Ink cartridge joint drive motor may
hit on the Flat cable, when the Ink cartridge holder unit is raised up, and damage the cable.
1. Follow the instructions given earlier in this chapter on the, "Ink spill prevention from the Ink cartridge holder
unit", take the steps needed to prevent the ink spillage when opening up the Ink cartridge holder.
2. Open the Ink cartridge holder unit to the vertical position following the instruction given in the, "Ink spill
prevention from the Ink cartridge holder unit" procedure described earlier in this section.
< The vertical tilting of the Ink cartridge holder will allow quick filling of the ink, especially when the ink volume in
the ink cartridge is low.>
Make sure to lock the Ink cartridge holder unit position by a screw to prevent the Ink cartridge holder
from folding down.
Fix the position of the Ink cartridge
holder unit with a screw to prevent
the holder from falling down.
3. Turning ON the machine power will start the Initial ink filling action.
4. The Test Mode No. 2711 [Head Replacement Mode] initial ink filling action ends after automatic Head cleaning
action. Do not operate nor go into any other test mode until the Initial ink filling action is completely finished.
5. Test Mode No. 2711 will automatically go back to setting [0] after the ink is filled.
6. Gently close the Ink cartridge holder back to its original flat position.
7. Put all the covers back.
Ink cartridge joint drive motor
Make sure that the Flat cable has a good
bend long the black line on the cable.
[ 11A-30 ]
ComColor Series (Revision 2.4)