Riso ComColor X1 series Technical Manual page 616

Data Editing (D)
No. Process Name
Booklet Staple Position Adjustment
4768
(Large)
Booklet Staple Position Adjustment
4769
(Small)
4770 Booklet Rear Tamping Adjustment
4771 Max Booklet Stapling
4772 Max Booklet Non-stapling
4773 Booklet Compile Calibration 1
4774 Booklet Compile Calibration 2
4775 Z-Fold Stacker Tray Setting
4776 Folding Time
4777 Z-Fold 1 8K GCO
4778 Z-Fold 2 8K GCO
4779 Z-Fold 1 A3
4780 Z-Fold 1 11X17
4781 Z-Fold 1 B4
4782 Buffer Sheet Timing
OPTIONS / Finisher
Default Unit/Range
100 0-200
100 0-200
20 5-35
15 2-25
5 1-15
100 0-200
100 0-200
100 0-255sheet
1 0-3time
50 10-90
50 10-90
50 10-90
50 10-90
50 15-90
60 1-200
[ 16-73 ]
Description
Adjusts the staple position when paper is
folded twice in booklet staple mode. (Paper
larger than B4S)
[• When the staple is higher than the fold
position
Difference (mm)x10* is subtracted from the
current NVM value and entered.
• When the staple is lower
(1=0.1mm)
Adjusts the staple position when paper is
folded twice in booklet staple mode. (Paper
smaller than B4S)
[Same as above]
(1=0.1mm)
Adjusts the amount of tamping only at the rear
during regular tamping in booklet compiling.
(1=0.2618mm)
The maximum quantity of sheets bound when
stapling in booklet mode.
The maximum quantity of sheets bound when
not stapling in booklet mode.
[Adjustment value (based on number of
sheets) for the amount of movement toward
the folding position on the leading edge of
paper, from the compile position to the fold
position (when the mode is fasten: OFF).]
Adjusts the compensation value when two
shee
(1=0.1mm)
[Same as above]
Adjusts the compensation value when three
sheets are folded.
(1=0.1mm)
Specifi es the quantity of sheets of the other
size ejected for subtraction of the quantity of
z-fold sheets of A3SEF and 11x17 SEF ejected
in the stacker tray.
Specifi es the number of times of forward-
backward rotation of the booklet folder roller
during folding.
Adjusts the roller position when the fi rst fold
is made during z-folding for 8K GCO, and
adjusts the position where the leading edge of
paper stops.
Adjusts the roller position when the second
fold is made during z-folding for 8K GCO, and
adjusts the position where the leading edge of
paper stops.
Adjusts the roller position when the fi rst fold is
made during z-folding, and adjusts the position
where the leading edge of paper stops.
Adjusts the roller position when the fi rst fold is
made during z-folding, and adjusts the position
where the leading edge of paper stops.
Adjusts the roller position when the fi rst fold is
made during z-folding, and adjusts the position
where the leading edge of paper stops.
Specifi es the time for sending delay regarding
the second sheet transferred for output when
two buffer sheets are ejected.
Test Modes
Rev.1.00