Riso ComColor X1 series Technical Manual page 641

Test Modes
5-4-3. Unit Checking (U)
Unit Checking (U)
3415 HCF P-F Tray Paper Length (Wide)
For paper size detection, set 297mm A/D value.
3416 HCF P-F Tray Paper Length (Narrow)
For paper size detection, set 105mm A/D value.
3417 HCF P-F Tray Move to Upper Limit Position
Rotate the elevator motor and stops the P- F Tray at upper limit position.
Then execute the follow up action in the upper limit position.
Upper limit position can be adjusted by the Test Mode [P-F Tray Upper Limit Position]
3418 HCF P-F Tray Move to Lower Limit Position
Rotate the elevator motor and stops the P- F Tray at lower limit position.
3419 HCF HCF Middle Entrance Sensor Automatic Light Intensity Adjustment
Auto adjustment of the intensity of light for the HCF Middle Entrance Sensor.
3450 HCF Nip Release Unit 1 Cycle Action
1. HCF nip release unit move to the nip position
2. HCF nip release unit move to the release position
If the unit is not in correct position, move to nip position again and do above cycle.
3452 HCF Nip Release Unit Release Position
Move the HCF nip release unit to the release position.
3453 HCF Nip Release Unit Nip Position
Move the HCF nip release unit to the nip position.
3454 HCF P-F Tray Maintenance Position
Move the HCF P-F Tray to upper limit position, then lower the P-F Tray to the 10% paper remaning position.
5-4-4. Initialization (I)
Initialization (I)
3525 HCF EEPROM Initialization
All data in HCF EEPROM are put back to default.
Rev.1.00
OPTIONS / High Capacity Feeder
Upper: No./Process Name, Lower: Description
OPTIONS / High Capacity Feeder
Upper: No./Process Name, Lower: Description
[ 16-98 ]