Riso ComColor X1 series Technical Manual page 462

Type S99: Software Error
!!System Error!!
Display Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
0006
<Software bug caused by invalid logic or other problems><CPU for SS controlling paper transfer>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><When emergency stop
0007 1
error occurs>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><When emergency stop
0007 2
error being solved>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><When recovery error
0007 3
occurs>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><When recovery error being
0007 4
solved>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><When paper fl oating error
0007 5
occurs>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><During the calculation
0007 6
process>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><During reception of internal
0007 7
processing>
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><When fi nish reception of
0007 8
internal processing>
0007 9
<Software bug caused by invalid logic><DSP for SS controlling paper transfer><At invalid data detection>
0008 1
<Software bug caused by invalid logic><CPU for SS controlling paper transfer><Cause 1>
0008 2 <Software bug caused by invalid logic><CPU for SS controlling paper transfer><Cause 2>
0008 3
<Software bug caused by invalid logic><CPU for SS controlling paper transfer><Cause 3>
0008 4
<Software bug caused by invalid logic><CPU for SS controlling paper transfer><Cause 4>
0010
The SS controlling paper transfer have detected a tray elevator sequence error.
0012 The FU paper receiving tray unit is not connected, but face up ejection is specifi ed.
0013
During a printing job, the next page data nor stop signal does not come within one minute.
0034
Restoring from mirrored data is not completed in time.
In job output processing in the engine interface SS, the page information fi le could not be acquired in the
0037
default directory.
In job output processing in the engine interface SS, the format of the page information fi le did not match the
0038
prescribed format.
In image expansion processing in the engine interface SS, the PRN fi le could not be acquired from the
0039
default directory.
In image expansion processing in the engine interface SS, there was an invalid job type in the page
0040
information fi le.
In image expansion processing in the engine interface SS, an invalid value was detected in the supported
0041
printing size.
0042 An error was returned for a system call in the PMS.
0043
Errors such as [fopen] or [fclos]e occurred after fi le access function calls.
Mirroring was performed for counter data and test mode setting values, but the mirroring fi le could not be
0070
created correctly on the control PCB unit hard disk, preventing backup.
Mirroring was performed for counter data and test mode setting values, but the mirroring fi le on the control
0071
PCB unit hard disk was invalid, preventing the restore.
No response between subsystems in the control PCB unit when instructed to start communication for
initialization
0073 1-6
Variation code: 1: Engine interface SS, 2: External interface SS, 3: Operation panel SS, 4: Network SS, 5:
Image adjustment SS, 6: Security SS
No response between subsystems in the control PCB unit when instructed to start communication in
0074 1-6
preparation for power OFF
Variation code: Same as above
Invalid logic or other problems involving system control have caused a software bug (detected by the
0075 1-2
controller).
[ 15-31 ]
Panel Messages