Waste Ink Tank & Waste Ink Tank Holder - Riso ComColor X1 series Technical Manual

Waste Ink Section
2-8. Waste Ink Tank & Waste Ink Tank Holder
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the Waste ink cover. (Refer to Chapter 2)
3. Unhook the ink tube mount from the machine. <Refer to
4. Unscrew and remove the cap on the Waste ink tank and hook the removed cap upsidedown on the cap holder.
<Refer to (2) on the photograph below.>
5. Mount the new cap, which comes with the new replacement Waste ink tank, on the existing waste ink tank.
6. Remove the existing Waste ink tank.
7. Disengage the pivot shaft of the Waste ink tank in the order of Front and then the Rear, and remove the Waste
ink tank holder from the machine.
Caution in assembly:
In putting the cap on the Waste ink tank, make sure that the waste ink tube is not twisted nor bent (folded).
< Refer to the next page for the photographs of GOOD example and BAD example.>
The photographs show the GOOD and BAD examples of how the waste ink tube should be when the Cap is placed
on the Waste ink tank or when the Maintenance unit (ink pan) is put back in the machine.
If the Waste ink tube is twisted or bent, the tube may rip, crack or unplugged and leak ink.
Also a large twist may cause the Waste ink tube to be pulled inside the machine, causing the Open/Close
movement of the Tray 1 to hit on the Waste ink tube and crack open the tube.
(1) on the photograph below.>
Waste ink tube mount
[ 12-16 ]
Cap
ComColor Series (Revision 2.4)