Riso ComColor X1 series Technical Manual page 109

Registration Section
4) Remove the Flat Gear; m1x36x4.
Flat Gear; m1x36x4
5) Slide the Slider to match the 3 mm diameter positioning hole on the Slider against the 3 mm diameter hole on
the Tray.
Slider
3 mm diameter positioning hole
6) While the two 3 mm hole are aligned, put back the previously removed Flat Gear; m1x36x4.
7) Put back the size detection device cover plate to complete the adjustment.
[ 5-29 ] ComColor Series (Revision 2.4)