Ink Spill Prevention From The Ink Cartridge Holder Unit - Riso ComColor X1 series Technical Manual

2-2. Ink Spill Prevention from the Ink Cartridge Holder Unit

Follow this procedure before swing opening the Ink cartridge holder unit in the vertical open position to
prevent ink spillage from the Ink cartridge holder.
Ignoring this procedure may cause the spilled ink to stain the machine interior with the ink.
1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Pull out the four Ink cartridges from the Ink cartridge holder unit.
3. Using lint-free paper or cloth, wipe clean the pooled ink from the Ink cartridge holder unit.
4. Do the same in the area beyond the Ink cartridge joint nozzle on the machine.
5. Insert the four Ink cartridges firmly back in the machine.
6. Turn ON the machine power and confirm that the Ink cartridge joint drive motor operates and mechanically joins
the Ink tubes to the Ink cartridge holder unit.
< If not required to supply ink into the machine, skip this step-6.>
Pooled dripped ink
Pooled dripped ink
[ 11A-17 ]
Absorb and wipe clean the ink
Absorb and wipe clean the ink
Joined and hooked.
ComColor Series (Revision 2.4)
Ink Flow Section