Internal Paper Feed Unit (Tray 3) - Riso ComColor X1 series Technical Manual

Registration Section

2-3. Internal Paper Feed Unit (Tray 3)

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the center inner cover. (Refer to Chapter 2.)
3. Remove the left inner cover. (Refer to Chapter 2.)
4. Remove the bottom inner cover. (Refer to Chapter 2.)
5. Remove the rear cover center assembly. (Refer to Chapter 2.)
6. Put the power supply unit in maintenance position. (W sems screw 4x8 (2 pcs))
7. Pull out trays 1, 2 and 3.
8. Remove the Tray rail guide from the left Tray rail of the Tray 2. (Shouldered screw x 1 pc).
9. Remove the Tray rail of tray 2 (left side). (IT3C screw 3x8;1 pc front and IT3C screw 4x8;1 pc rear)
10. Disconnect the wire connector and remove internal paper feed clutch 3. (5 mm dia. E-ring)
11. Slide the gear and gear-pulley out of the way (1 pc each). (6 mm dia. E-ring (1 pc each))
12. Remove the metal bushing. (6 mm dia. E-ring)
13. Remove the mounting screw of the internal paper feed unit (tray 3) in back. (IT3C screw 4x8 (1 pc))
14. Remove the mounting bracket of the internal paper feed unit (tray 3) in front. (IT3C screw 4x8 (3 pcs))
Note: Use a 5.5 mm wrench.
15. Disconnect the wire connector from the machine frame on the back of the unit . (1 pc)
<Do not forget to re-plug the wire connector in assembly.>
16. Remove the internal paper feed unit (tray 3) from the top, in front.
Tray Rail Guide (Left) removed and the Rail mounting screw visible.
5.5 mm wrench
Tray Rail Guide (Left)
[ 5-18 ]
Tray Rail left (TRAY 1)
Tray Rail left (TRAY 2)
Tray Rail left (TRAY 3)
Mounting screws of the Bracket.
ComColor Series (Revision 2.4)