Riso ComColor X1 series Technical Manual page 473

Panel Messages
Type U09: Mail maker motor lock error
The Mail maker has an error.
Display Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
Could not detect the MM End Tamper HP Sensor while running the motor. (Motor synchronization loss,
3665
Malfunction of the sensor, etc.)
3666
Could not detect the MM Side Tamper HP Sensor while running the motor. (Same as 3665)
3667 Could not detect the MM Body Hit HP Sensor 1 while running the motor. (Same as 3665)
3668
Could not detect the MM Body Hit HP Sensor 2 while running the motor. (Same as 3665)
3669
Could not detect the MM Form Horizontal HP Sensor while running the motor. (Same as 3665)
3670 Could not detect the MM Form Hit HP Sensor 2 while running the motor. (Same as 3665)
3671
Could not detect the MM Form Hit HP Sensor 3 while running the motor. (Same as 3665)
Type U10: Scanner EEPROM error
The scanner settings are not realized properly.
Display
Call service.
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Clear
Note: To resolve the underlying problem, access test mode 5406 (scanner profi ling mode) to store scanner
profi ling data in fl ash memory. If the error persists, cool off the unit and access test mode 5406 again.
Point Description
4133
Setting values on Test mode No.5631, 5632 & 5633 are out of range.
Type U11: Puncher unit error
The fi nisher punching unit has an error.
Display
Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
3060 After operation was started, the side registration sensor was not deactivated in time.
Type U12: Stapler unit error
The fi nisher stapler unit has an error.
Display
Press RESET key or Reboot by press the Sub Power Key
If recovery has failed, call service.
Clear
Press the Reset key, or turn OFF the printer. (Turn OFF the printer through sub power key.)
Point Description
3061
After operation was started, the stacker front position sensor was not activated in time.
3062
After operation was started, the tamper home sensor was not deactivated in time.
3063
After operation was started, the tamper home sensor was not activated in time.
3064 After operation was started, the end wall home sensor was not deactivated in time.
3065
After operation was started, the end wall open sensor was not activated in time.
3066
After operation was started, the end wall home sensor was not activated in time.
3067 After operation was started, the end wall open sensor was not deactivated in time.
3068
After operation was started, the eject clamp up sensor was not deactivated in time.
3069
After operation was started, the eject clamp up sensor was not activated in time.
3070
After operation was started, the shelf home sensor was not deactivated in time.
3071 After operation was started, the shelf home sensor was not activated in time.
3072
After operation was started, the staple home sensor was not activated in time.
3073
After operation was started, the staple move home sensor was not deactivated in time.
3074 After operation was started, the staple move home sensor was not activated in time.
3075 After operation was started, the staple center position sensor was not activated in time.
3076
After operation was started, the staple center position sensor was not deactivated in time.
3077
After operation was started, the sub paddle home sensor was not activated in time.
3078 After operation was started, the sub paddle home sensor was not deactivated in time.
[ 15-42 ]