Option
4-50. Reverse Roller Motor
1. Remove the Offset Guide Assembly.
2. Remove the Spring.
3. Remove the Reverse Roller Motor Assembly. (W-sems 3x6 (2 pcs))
4. Unplug wire connector from the motor.. (1 pc)
4-51. Reverse Roller Elevation Motor removal
1. Remove the Offset Guide Assembly.
2. Remove Snap Ring. (1 pc)
3. Slide the tip end of the Link Lever out of the shaft.
4. Remove the Reverse Roller Elevation Motor Assembly. (W-sems screw 3x6 (2 pcs)
5. Unplug the wire connector from the motor.
[ 19-87 ]
Reverse Roller Motor
Spring
Link Lever
Snap Ring
Reverse Roller Elevation Motor
[ 19-87 ]
Face Down Offset Stapler