I/F Module; Basic Mechanism - Riso ComColor X1 series Technical Manual

I/F Module

1. Basic mechanism

Explanation
• The papers ejected out from the optional FU Ejection Unit are transferred to the I/F Module and then transferred
further into the Multifunction Finisher.
• The circumferential speed of the I/F Transfer Roller is 99% to that of BP Belt running at circumferential speed of
632mm/second.
• The paper ejecting out from the I/F Transfer Roller is pulled by the Assist Roller at circumferential speed of
1000mm/second.
• The speed difference between the I/F Transfer Roller and Assist Roller is absorbed by the one-way clutch
mounted on the I/F Transfer Roller drive unit.
• The paper being transferred through the I/F Module is monitored by the Decurler IN Sensor and Decurler OUT
Sensor.
• The I/F Module Front Door Switch checks whether the Front Door of the I/F Module is closed or open.
If the door is detected open (switch = OFF), the +24 volt electrical supply to the Multipurpose Finisher is
stopped.
[ 24-27 ]
Multifunction Finisher II (option)
x1 Series ComColor (Revision 0.9)