Disassembly; Maintenance Unit - Riso ComColor X1 series Technical Manual

2. Disassembly

2-1. Maintenance Unit

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the ejection cover and waste ink tank cover. (Refer to the section on covers in Chapter 2.)
3. Remove the right rear cover. (Refer to the section on covers in Chapter 2.)
4. Unplug the maintenance unit wire connector and re-use band.
Re-use band
5. Open the right front cover.
With the maintenance unit under the head holder, pull out the clip and sleeve on the end of the hinge pin
connecting the maintenance unit and arm, from the front. Similarly, pull out the clip and sleeve in back from the
position where the ejection side cover opens.
Clip and sleeve (front)
[ 12-7 ]
Waste Ink Section
Connector
ComColor Series (Revision 2.4)