Riso ComColor X1 series Technical Manual page 12

Maintenance
At least 250mm in shaft length
or
Long screw driver or Rachet wrench
Either of these tools will become necessary in
mounting the front bottom cover on the
machine during the machine installation.
Normal millimeter size screw driver with one-
eighth marking on the grip end.
The one-eighth marking on the grip end is
needed in aligning the Print head angle during
the image adjustment.
Metal ruler (with the width less than 15mm).
Metal ruler with the width less than 15mm is
required to open the front door of the machine
with the machine power OFF.
It can be substituted with similar dimension
object of any material (scale not required).
Feeler gauge in millimeter thickness.
The feeler gauge is required in adjusting the
parallelism of the Registration roller against the
BP unit.
4mm diameter shafts (2 pieces).
2 pieces of 4mm diameter jig shafts are
required in removing and replacing the BP belt
on the BP unit.
Adjustable wrench.
Adjustable wrench is required to adjust
the height of the machine during the machine
installation.
[ 1-12 ]
ComColor Series (Revision 2.4)