Flipper Sensor; Upper Transfer Unit - Riso ComColor X1 series Technical Manual

Paper Transfer Section

2-8. Flipper Sensor

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the center inner cover. (Refer to Chapter 2.)
3. Remove the two stoppers and pull out the upper transfer unit. (Round tip IT3C screw 4x8 (1 pc each)).
4. Remove the left and right top covers. (Binding screw 4x8 (3 pcs each))
5 Remove the control panel together with the mounting bracket. (Round tip IT3C screw 4x8 (2 pcs), Pan-head
screw 4x8 (1 pcs)).
6. Put the ink holder unit in maintenance position.
7. Remove the flipper sensor together with the mounting bracket. (Pan-head screw 3x6 (2 pcs))
8. Remove the flipper sensor from the bracket. (Binding screw 3x6 (1 pc))
Note: After the replacement, check the operation by test mode 1106 (flipper sensor).

2-9. Upper Transfer Unit

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the center inner cover. (Refer to Chapter 2.)
3. Remove the two stoppers. (Round tip IT3C screw 4x8 (1 pc each))
4. Pull the upper transfer unit fowrard, out of the machine.
Flipper sensor
[ 8-8 ]
Upper transfer unit
ComColor Series (Revision 2.4)