Riso ComColor X1 series Technical Manual page 492

Type W43: Specifi ed size not loaded in slip sheet tray
Load slip sheets in the following tray.
Display Selected tray: (1)
Note: As (1) in the message displayed, the paper feed tray or a tray from 1 to 3 is indicated.
Do one of the following.
• Load paper of the correct size in the slip sheet tray.
Clear
• Press the Cancel button.
• Delete the job.
Point Description
1015 1 No paper of supported size loaded in the slip sheet tray (error detected by controller)
1015 2
Same as above (error detected by engine control)
Type W44: Specifi ed size not loaded in cover tray
Load cover sheets same size as the body sheets in the following tray.
(1)(2)(3)
Display
Note: As (1) in the message displayed, front cover or back cover is indicated, as (2), the paper feed tray or a
tray from 1 to 3 is indicated, and as (3), the paper size is indicated.
Do one of the following.
• Load paper of the correct size in the cover tray.
Clear
• Press the Cancel button.
• Delete the job.
Point Description
No cover paper of the same type and size as this set* is loaded.
1016 1
*When Z folding is activated, paper of the correct size after Z folding (error detected by controller)
No cover paper of the same type and size as this set* is loaded.
1016 2
*When Z folding is activated, paper of the correct size after Z folding (error detected by engine control)
No back cover paper of the same type and size as this set* is loaded.
1017 1
*When Z folding is activated, paper of the correct size after Z folding (error detected by controller)
No back cover paper of the same type and size as this set* is loaded.
1017 2
*When Z folding is activated, paper of the correct size after Z folding (error detected by engine control)
Type W45: Unsupported combination of paper sizes
Job name: ( )
Display
Part of the data is prepared on a page of a paper size that cannot be output with the Z fold setting.
Check the data. (The job has been cancelled.)
Do one of the following.
Clear
• Press the Close button.
• Delete the job.
Point Description
During paper transfer, jobs are started or resumed with a combination of sizes other than A4 Landscape and
A3, B5 Landscape and B4, or Letter Landscape and Ledger with all of the following settings.
• Mixed size ON
1004 1-2
• Z folding activated
• Input tray: Auto
Variation code: 1: Error detected by controller or related components; 2: Error detected by engine or related
components
Type W46: No tray for auto ejection
Display Auto feed tray selection is not available. Select the tray and press the START key.
Do one of the following.
• Press the Select tray button and manually specify the tray.
Clear • Add a tray candidate for auto tray selection.
• Press the Cancel button.
• Delete the job.
Point Description
When the input tray selection is Auto, the setting Auto selection is deactivated for all trays (error detected by
1018 1
controller).
1018 2 Same as above (error detected by engine control).
[ 15-61 ]
Panel Messages