Riso ComColor X1 series Technical Manual page 861

Multifunction Finisher II (option)
3-4. Eject clamp
• Paper is transported toward the Stacker Tray by the Compile Eject Roll and Compile Feed Roll, which are both
driven by the Compile Eject Motor.
• Paper transport status is detected by the Compile Exit Sensor.
• The Clamp section attached to the Compile Feed Roll is designed to move vertically. When it is raised, nipping
by the Compile Eject Roll and Compile Feed Roll is released.
• Vertical movement of the Clamp section is driven by the Eject Clamp Motor. The Clamp section raised position is
detected by the Eject UP Sensor.
• When the Eject Opening section opens, the Eject Safety SW turns OFF and cuts off the +24-VDC power supply
to the Staple Motor located inside the Stapler Head.
Feeding the first paper sheet
• For the first sheet of paper, the clamp will descend. The Eject Roll and Feed Roll will then send the paper toward
the Stacker Tray.
• When the trailing edge of paper passes the Compile Eject Sensor, the Eject Roll and Feed Roll rotate in reverse,
sending the paper toward the Compile Tray in the reverse direction.
Feeding the second and subsequent paper sheets
• For the second and subsequent paper sheets, the clamp lifts to block paper transport.
• Paper passing the Compile Eject Roll falls onto the Compile Tray.
Discharge of set paper
• The clamp descends and the Eject Roll and Feed Roll discharge paper toward the Stacker Tray.
Eject Motor
Eject Clamp Motor
Eject UP Sensor
Compile Eject Roll
Compile Feed Roll
[ 24-46 ]
Compile Eject Sensor
x1 series ComColor (Revision 0.9)