Riso ComColor X1 series Technical Manual page 908

4-2. Staple position adjustment
> The adjustment is made by changing the parameter settings of the Test Modes.
> Separate adjustments must be made for each paper size and stapling layout.
(1) Perform printing or print test pattern to check for staple position deviations.
(2) If staple position deviations are observed, adjust the Test Mode parameters.
• Increasing the setting value moves the staple positions toward the rear.
A ± 2.0 mm
Specifications
Paper size
8 x 10 SEF
A4 SEF
8.5 x 11 SEF
A4 Cover SEF
Custom A4 SEF
9 x 11 SEF
8 x 10 LEF
B5 LEF, B4 SEF
Executive LEF
8.5/9 x 11 LEF, 11 x 15/17 SEF
A4/A4 Cover LEF, A3 SEF
List of Test Modes
ComColor
HC Finisher
Multipurpose
< as
Finisher Reference>
Test Mode No.
Test Mode No.
4743 763-223
4749 763-229
4875 763-355
4876 763-356
4900 763-380
Dimension A (mm)
23.85
27.25
30.2
33.75
35.25
36.55
49.25
50.75
55.75
61.95
70.75
Program
Item
Default
REAR STAPLE
100
POSITION 1
REAR STAPLE
100
POSITION 2
DUAL STAPLE
FRONT MOVE 20
ADJUSTMENT
DUAL STAPLE
PITCH 20
ADJUSTMENT
REAR STAPLE
100
ADJUSTMENT
[ 24-93 ]
Multifunction Finisher II (option)
Dimension B (mm)
197.2
204
209.9
204
220
222.6
248
251
261
273.4
291
Range
Unit/Step
(min./max.)
One pulse is
50–150 pulses
0.157 mm
One pulse is
50–150
0.157 mm
One pulse is
0–40
0.157 mm
One pulse is
0–40
0.157 mm
One pulse is
50–150
0.157 mm
x1 Series ComColor (Revision 0.9)
REAR
FRONT
Description
Adjusts the rear staple
position for paper width
over 250 mm. (for other
than A4LEF and A3SEF).
Adjusts the rear staple
position (for A4LEF and
A3SEF).
Specifies the amount of
adjustment toward the
front during dual stapling.
Specifies the amount
of adjustment of the
staple pitch during dual
stapling.
Adjusts the rear stapling
position when paper 250
mm or narrower is used.
(Other than A4LEF and
A3SEF.)