Paper Feed Tray Elevation Switch; Paper Feed Tray Lower Safety Switch - Riso ComColor X1 series Technical Manual

External Paper Feed Section

2-13. Paper Feed Tray Elevation Switch

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the paper feed cover. (Binding screw 3x8 (2 pcs))
3. Remove the three connectors.
4. Remove the upper safety switch.
5. Remove the upper limit unit assembly. (Round tip IT3C screw 4x8 (3 pcs))
6. Remove the connector.
7. Remove the paper feed tray elevation switch
Note: After replacement, check operation in test mode 1035 (paper feed tray elevation switch).

2-14. Paper Feed Tray Lower Safety Switch

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the rear cover center assembly. (Refer to Chapter 2.)
3. Put the power supply unit in maintenance position. (W sems screw 4x8 (2 pcs))
4. Remove the lower safety switch spring.
5. Remove the paper feed tray lower safety switch (the entire mounting bracket). (IT3C screw 4x8 (1 pc))
Lower safety switch spring
Paper feed tray lower safety switch
[ 4-22 ]
ComColor Series (Revision 2.4)