Option
4-13. Control Board (PCB) tilting
1. Remove the Rear Cover.
2. Unplug wire connectors. (6 pcs)
< One over the top left corner, three on the left bottom corner, two from the pulse motors on the left hand side.>
3. Detach the Control Board (PCB) from the unit and gently tilt and hang it down, paying caution not to scratch the
PCB surface. (W-sems screw 3x6 (4 pcs), W-sems screw 4x8 (1 pc))
[ 19-47 ]
Control Board (PCB)
Control Board (PCB)
[ 19-47 ]
Face Down Offset Stapler