Switchback Unit B - Riso ComColor X1 series Technical Manual

Switchback Section
13. Remove Switchback unit A. (Round tip IT3C screw 4x8 (4 pcs))
< REAR >

2-4. Switchback Unit B

1. Turn OFF the machine power and disconnect the power cable from the power source.
2. Remove the center inner cover.
3. Remove the left inner cover.
4. Remove the rear cover center assembly.
5. Put the engine control PCB in maintenance position. (IT screw 4x8 (2 pcs))
6. Remove the timing belt.
7. Unplug the wire connector. (3 pin connector in the back.)
8. Release the lever hook of the paper jam release E1.
9. Remove the Switchback unit B from the front. (Round tip IT3C screw 4x8 (2 pcs))
Timing belt
Switchback unit A
(Refer to Chapter 2 of this book)
(Refer to Chapter 2 of this book)
(Refer to Chapter 2 of this book)
[ 10-10 ]
< FRONT >
Switchback unit B
ComColor Series (Revision 2.4)
E1 Lever hook